To enable a network component

1. Open Network Connections.
2. Right-click a connection, and then click Properties.
3. Do one of the following:
• If this is a local area connection, on the General tab, in This connection uses the following items, select the check box next to the client, service, or protocol you want to enable.
• If this is a dial-up or VPN connection, on the Networking tab, in This connection uses the following items, select the check box next to the client, service, or protocol you want to enable.
• If this is an incoming connection, on the Networking tab, in Network components, select the check box next to the client, service, or protocol you want to enable.

Notes

• XOX
• You should only enable the network components that you need, for the following reasons:
  • Network performance is enhanced and network traffic is reduced when only the required protocols and clients are enabled.
  • If your computer encounters a problem with a network or dial-up connection, it attempts to establish connectivity by using every network protocol that is installed and enabled. By only enabling the protocols that your system can use, the operating system does not attempt to connect with protocols it cannot use, and returns status information to you more efficiently.
  • Excessive services can hinder performance on your local computer.

Related Topics